Special attention items: 1. This test equipment is a test system with more complete functions, more advanced performance, and more complicated operation. The indoor environment should be tidy and clean, and there should be no dust particles and irritating and corrosive gases around the equipment, and the ventilation should be good; the equipment should be equipped with an independent circuit breaker and well grounded. 2. The pneumatic impact impact test bench is placed on the flat ground on the first floor. A 700X850 rubber sheet with a thickness of 10mm should be placed on the bottom of the equipment to reduce the vibration of the equipment on the ground during operation. The equipment may move by itself during long-term collisions. If necessary, use anchor screws to fix the equipment (an anchor screw hole is designed). The equipment covers an area of about 1.5mX2.5m, and the main body of the equipment is AC220V, 1KW. The gas source is self-provided. It is best to use a 0.8MPa industrial gas source. When using an air compressor, it must be able to ensure that the output pressure of the air compressor remains stable. The pressure and flow rate of the air compressor will affect the maximum frequency of the collision table and the repeatability of the parameters and operation. The interface of the air source of the equipment is a φ10 PU pipe. 3. The equipment will have a strong impact on the ground and cause vibration. If there is an event request that is sensitive to the vibration environment near the equipment, a reasonable placement location should be considered